How to Start Oil Painting for Beginners

Five tubes, three brushes, and one rule: fat over lean

Oil paint looks intimidating, but the basics are simple. You need a few colors, a surface, a medium, and patience. This guide covers what to buy, how layers work, and a first exercise you can finish in one afternoon.

Questions and Answers

What colors should a beginner buy?

Start with titanium white, ultramarine blue, cadmium red (or a hue), cadmium yellow (or a hue), and burnt umber. These mix almost any color you need.

Do I need turpentine?

No. Odorless mineral spirits are safer for cleaning brushes. Many beginners skip solvent entirely and clean with safflower oil and soap.

How long does oil paint take to dry?

Thin layers are often touch dry in one to three days. Thick passages can take weeks. Wait about six months before varnishing.

What does fat over lean mean?

Each layer should hold a little more oil than the one below. Lean layers first, oilier layers on top. This helps prevent cracking.

What surface is best to start on?

Pre-primed canvas panels are cheap and easy. Small sizes, around 8 by 10 inches, keep practice sessions short.

A short supply list

  • Five student grade tubes listed above
  • Three hog bristle brushes: a flat, a filbert, and a small round
  • A palette knife and a glass or paper palette
  • Linseed oil or a ready-made medium
  • Odorless mineral spirits in a lidded jar
  • Rags or paper towels

Set up a safe workspace

Open a window or run a fan. Keep solvents capped when not in use. Oil soaked rags can self heat, so spread them flat to dry or store them in water inside a closed metal can.

Tone the canvas first

Bright white canvas makes it hard to judge values. Thin a little burnt umber with solvent and rub a light, even tone across the surface. It dries fast and gives you a middle value to work from.

Your first exercise: a three value still life

Place an egg or a mug under a single lamp. Block in the shadow shape with thin umber. Add the middle tone, then the light. Ignore color for now. Learning to see light and dark is the real skill.

Next, repeat the same setup with limited color. Mix each value on the palette before it touches the canvas. Clean your brush between warm and cool mixes to avoid gray mud.

Common beginner mistakes

Using too much medium early, overworking wet paint, and starting with details are the big three. Work large shapes first. Stop when the painting reads clearly from a few steps back.

Learn from the masters

Rembrandt built his portraits over a toned ground with thin darks and thicker lights. Study his self-portraits to see how few colors he needed. Later, try underpainting and glazing.

I keep on making what I can’t do yet in order to learn to be able to do it.

Vincent van Gogh, letter to Anthon van Rappard, 1885

Related reading on WooArts


Written

in

, ,